You can specify settings for the reboot process.
To enable the reset command and display it in the Device menu:
From the Tools menu, select Options. The Options window displays.
Click the Customization tab.
In the lower part of the window, select Enable reset commands and allow them to be shown as menu items.
Click Apply to save and leave the window open.
Click OK to save and close the window.
To set reboot wait times:
From the Tools menu, select Options. The Options window displays.
Click the Customization tab.
In the lower part of the window, specify the following:
|
Device reboot wait time (Unicast) |
Select the number of seconds the unit should unicast messages while waiting for a reboot. The unit attempts a series of unicasts before broadcasting. |
|
Device reboot wait time (Broadcast) |
Select the number of seconds the unit should broadcast messages while waiting for a reboot. The unit attempts a series of broadcasts after completing unicasts. |
Click Apply to save and leave the window open.
Click OK to save and close the window.
Note: After rebooting, search again for other devices on the network.
See also